C8051T606ZDB

System Overview

C8051T600/1/2/3/4/5/6 devices are fully integrated, mixed-signal, system-on-a- chip MCUs. Highlighted features are listed below. Refer to Table 2.1 for specific product feature selection and part ordering numbers.
With on-chip power-on reset, VDD monitor, watchdog timer, and clock oscillator, the C8051T600/1/2/3/4/5/6 devices are truly stand-alone, system- on-a-chip solutions. User software has complete control of all peripherals and may individually shut down any or all peripherals for power savings.

Analog Peripherals

- 10-Bit ADC (‘T600/602/604 only)
• Up to 500 ksps
• Up to 8 external inputs
• VREF external pin, Internal Regulator or VDD
• Internal or external start of conversion source
• Built-in temperature sensor
- Comparator
• Programmable hysteresis and response time
• Configurable as interrupt or reset source
• Low current
On-Chip Debug
- C8051F300 can be used as code development platform; complete development kit available
- On-chip debug circuitry facilitates full speed, non-intrusive in-system debug
- Provides breakpoints, single stepping, inspect/modify memory and registers Supply Voltage 1.8 to 3.6 V
- On-chip LDO for internal core supply
- Built-in voltage supply monitor

Temperature Range: –40 to +85 °C

Package Options:
- 3 x 3 mm QFN11
- 2 x 2 mm QFN10 (C8051T606 Only)
- MSOP10 (C8051T606 Only)
- SOIC14 (C8051T600/1/2/3/4/5 Only)

High-Speed 8051 µC Core

- Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks
- Up to 25 MIPS throughput with 25 MHz clock
- Expanded interrupt handler

Memory

- 256 or 128 Bytes internal data RAM
- 8, 4, 2, or 1.5 kB byte-programmable EPROM code memory

Digital Peripherals

- Up to 8 Port I/O with high sink current capability
- Hardware enhanced UART and SMBus™ serial ports
- Three general purpose 16-bit counter/timers
- 16-bit programmable counter array (PCA) with three capture/compare modules
• 8 or 16-bit PWM
• Rising / falling edge capture
• Frequency output
• Software timer

Clock Sources

- Internal oscillator: 24.5 MHz with ±2% accuracy supports crystal-less UART operation
- External oscillator: RC, C, or CMOS Clock
- Can switch between clock sources on-the-fly; useful in power saving modes